Filter
Top Products
Loading Ribbon
Make sure the printer is configured to use a ribbon.
To load ribbon:
1.
Open the cover.
2.
Unlock the printhead by turning the retaining latch.
3.
Lift printhead assembly using the printhead tab until the
assembly locks into place.
4.
Push the deflector tab down.
5.
Slide the extra ribbon core on the take-up reel as far as it will
go with the "Monarch This End Out" writing facing out. Use
your empty ribbon core as the take-up core. The take-up core
only fits on the take-up reel one way. (An extra take-up core
is available by ordering part number 117961.)
Deflector Tab
Printhead Assembly
3-2
Loading Ribbon