<DRB1239>
12
Handling Magazines
INSERTING DISCS INTO THE MAGAZINE
Because the Changer has a front-loading magazine slot,
inserting discs is easy. To insert discs into the magazine,
follow these steps:
Step 1
Open a disc tray (open one at a time) by placing your
thumb on the outer tab and pushing the tray out in a
counterclockwise direction.
Step 2
Place a CD-ROM disc
label side ≠ down ≠,
shiny side
up in the tray.
Step 3
With your index finger on the disc tray tab, swing the
tray back into the magazine.
Repeat these steps until you have inserted each disc
into the magazine. Insert the magazine into the unit.
WARNING:
Discs must be placed in the disc tray label side ≠
down ≠, shiny side up.
HANDLING OF CD-ROM DISCS
÷When holding discs, DO NOT touch the data surfaces
(the shiny side of the disc). Hold the disc by the edges
or by one edge and the center hole.
÷DO NOT affix labels or adhesive tape to either side of
the discs. Also, do not scratch or damage the
pre-existing label.
DO NOT use damaged, cracked, or warped discs. If
they break inside the unit, they may damage the optics.
Discs rotate at high speed inside the changing
mechanism.
MEDIA DIAMETER
120mm/12cm/4.72" discs only
SUPPORTED DISC FORMAT
Physical Format
The DRM-6NX changer supports 2048 Bytes/Block
format only. The supported physical formats are
Mode 1, Mode 2, form 1, Multi-session, and packet
write (Variable).
Logical Format
Logical format to be supported is basically ISO9660
(includes Rock Ridge and Joliet Extensions)
NOTES:
7
This unit does not support the use of CD-DA Audio Discs.
7
This product does not support some CD-R discs written with
packet writing. (This product does not support ISO9660 Level 3
discs which contain multi extent files. If these discs are used,
multiple same filenames appear in a directory.)