Filter
Top Products
<DRB1239>
13
Basic Installation
This section includes the basic setup procedures for
getting your PIONEER Network Cache Changer DRM-
6NX up and running:
÷Connecting the DRM-6NX to the network
÷Assigning an Internet address
÷Setting basic system parameters
You must configure the DRM-6NX and set up the
appropriate access restrictions for your specific network
environment. Proceed to the relevant sections of the
manual:
÷pp. 18 – 19 - Microsoft & IBM Networks (SMB)
÷pp. 20 – 24 - NetWare (NCP)
÷pp. 25 – 26 - UNIX (NFS)
÷pp. 27 – 28 - Web (HTTP)
Connecting the Network Cache Changer to
the Network
Before you begin
Always consult the Network Administrator before
making changes to the network configuration.
Procedure
To connect the DRM-6NX to your network, follow these
steps:
1.Turn off the power
2.Connect the network cable to the appropriate
connector
3.Turn on the power
The DRM-6NX front panel indicators will flash during
power-on and self-test. When the Status indicator stops
flashing and remains off, the DRM-6NX is ready for use.