Filter
Top Products
11
OfficeRight™ DI200
Operator’s Guide
Always fan (aerate) envelopes before
you load them. This prevents them
from sticking together.
Then tap the stack of envelopes onto a
firm surface to align the edges.
IMPORTANT:
Load envelopes right way up and
facing you. This means that the
envelope flap is on the back of the
envelope and at the top. Any other
orientation will prevent the machine
from inserting properly.
Place the envelope stack into Feeder B
with the back envelope flat against the
feed belts. There’s no need to “shingle”
or stagger the envelope stack.
Slide the two side guides up to the
envelope stack then
slightly
back them
off. Use the blue handles at the rear of
the guides when moving them.
The correct setting is achieved when
the guides control the envelopes but in
no way restrict their feed into the
machine or cause them to feed at an
angle (skew).
IMPORTANT: If the guides are too
tight, envelopes may not feed reliably; if the guides are too loose,
envelopes may skew as they feed into the machine.
Loading
Loading the Envelope Feeder (Feeder B)
03 A5 p11-18 6/16/03, 4:32 PM11