Filter
Top Products
E – 22
Operation with the Remote Control
Point the remote control toward the remote control sensor of the main unit and operate.
ASPECT
VIDEO
ON/STANDBY
SET
ESC
MENU
S
-
VIDEO YCbCr
DVI
ASPECT button
This button selects the vertical and horizontal
ratio of the screen of the input video.
These buttons are used for the
selection of the input signal.
For further information about input selection.
VIDEO button
This switches the input to the VIDEO signal.
S-VIDEO button
This switches the input to the S-VIDEO signal.
YCbCr button
This switches the input to the Y Cb Cr signal.
DVI button
This switches the input to the DVI-D signal.
ON/STANDBY button
This button is used to switch ON the power and set the unit
to the STANDBY mode.
These buttons are used for menu opera-
tions.
→
Page E-24 "Using the On-Screen Menu"
MENU button
This is used in the selection of the menu name when
displaying the menu on the projection screen.
ESC button
This is used when closing the menu.
SET button
This is used to set the menu items.
Cursor buttons (← → ↑ ↓)
These are used in the selection of the menu name, item
name, and contents.
ON/STANDBY
POWER
/
STATUS
Turning ON Power/STANDBY
Press the POWER button of the main unit and turn on the main
power.
To turn on the power:
Check that the POWER/ indicator of the main unit is lit or-
ange.
Press the ON/STANDBY button for about 2 seconds.
The power will be switched on, the indicator will flash green (for
one minute) and then the indicator will be lit green. The projec-
tion screen will brighten in about 40 seconds.
Setting standby mode:
Press and hold down the ON/STANDBY button for about 2 sec-
onds.
The indicator will flash orange (for 60 seconds) and then be lit
orange.
Attention!
When switching off the main power or disconnecting the power cord
First press ON/STANDBY button of the remote control or the main unit to set the standby mode (in which the indicator will
be lit orange) and then switch off the main power. If the main power of the main unit is switched off without setting the
standby mode, this could shorten the life of the lamp or possibly cause damage due to the heat of the lamp.
Light in orange
Light in green
Power ON
Standby
STATUS
POWER
/
Note: To save electrical power when not
using the unit, switch off the main power.
When doing so, wait until the flashing
orange indicator is lit steadily.