Filter
Top Products
E – 40
Replacing the Lamp Cartridge
NOTE: The projector lamp has its usable life.
The rated lamp life is about 1000 hours. How-
ever, it may become shorter depending on the
conditions of usage.
(The rated lamp life is the average life of the
lamps produced and tested, under the test con-
ditions of our company, for a long term.)
Ⅵ After the lamp has been operating for 1000 hours or longer, the STATUS indicator
will light and the message "Replace The Lamp" will appear on the screen. Should
this happen, turn off the projector and replace the lamp cartridge with a new one.
The projector will not turn on after 1100 hours.
Ⅵ Obtain a replacement lamp cartridge at the store where the projector was purchased.
Please specify the following information when ordering a replacement lamp cartridge:
Unit model number: HE-3100L for the exclusive use of HE-3100
Part number: 27-050.
CAUTION
Follow these steps before replacing the lamp cartridge:
Press the ON/STANDBY button on the remote control to turn off the power. The POWER/
indicator will change to steady
light in green from flashing in amber.
Press the POWER button on the projector cabinet turn off the projector.
Unplug the power cord.
Wait at least 60 minutes for the lamp cartridge to cool.
DO NOT TOUCH THE LAMP CARTRIDGE immediately after it has been used. It will be extremely hot.
Ⅵ Do not remove any screws except for those mentioned in the instructions below.
Ⅵ Do not touch the lamp. Doing so may shorten the lamp life.
Ⅵ The lamp may explode if improperly mishandled.
Ⅵ If lamp has reached the end of its usable life, the lamp bulb may shatter. When this happens, an explosive sound can be heard
and pieces of glass may be scattered in the lamp cartridge. Do not touch them as the pieces of glass may cause injury. If this
happens, contact your dealer or the store where the projector was purchased.
Preparation: Unplug the projector. Prepare the new lamp cartridge and a plus-headed screwdriver.
Lay a soft cloth sheet underneath the projector with its upside down to prevent scratches.
1
Remove the lamp cover.
q Loosen the lamp cover screw until it turns freely.
w Remove the lamp cover.
Lamp cover
2
Remove the lamp cartridge.
q Loosen the lamp cartridge screw until it turns freely.
w Hold the handle of the lamp cartridge and then pull out the
lamp cartridge.
Lamp cartridge