Filter
Top Products
E – 8
Names of the Main Unit Parts
O
N
/
S
T
A
N
D
B
Y
A
S
P
E
C
T
S
O
U
R
C
E
R
/
S
T
A
T
U
S
DVI-D
CO
MPONENT
CTRL
S-VIDEO
VIDEO
Y Cb Cr
Theft prevention locking hole
(See below)
Air intake hole
This is an air intake hole used for cooling the main unit.
Ventilation outflow hole
This ventilation outflow hole is used for cooling the
main unit and discharges the heat of the lamp.
DVI-D
COMPONENT
CTRL
S-VIDEO
VIDEO
Y Cb Cr
S-VIDEO connector
This is connected with the S-VIDEO output connector of the
equipment to be connected.
→
Page E-15
DVI-D connector
This is connected with the (24-pin) DVI-D output connector of the
equipment to be connected.
→
Page E-17
VIDEO connector
This is connected with the VIDEO output connector of
the equipment to be connected.
→
Page E-15
YCbCr connectors (COMPONENT)
These connectors are connected with the YCbCr output
connectors of the equipment to be connected.
→
Page E-16
CTRL connector
This connector is for service personnel only.
End users should not use this connector. Doing so by end users may
cause breakdown.
Front adjuster
These feet are used for height
adjustment.
→
Page E-9
Rear adjuster
These feet are used for height
adjustment.
→
Page E-19
Lamp cover
This cover is removed when replacing the lamp
cartridge of the light source.
→
Page E-40
Theft Prevention Lock
The theft prevention lock is supported by the Micro
Saver Security System manufactured by Kensington
Technology Group.