Filter
Top Products
2-- 2
Powerware 9330 (10 kV A--40 kVA) Installation and Operation
164201300 REV. G 061502
2.2 UPS Cabinet Installation
To install an UPS cabinet, perform the procedures in the following paragraphs.
2.2.1 Unloading the Powerware 9330 (10 kVA---20 kVA) UPS
Cabinet from the Pallet
The UPS cabinet is bolted to a wooden pallet supported by wood skids. To
remove the pallet, perform the following procedure:
WARNING:
The UPS cabinet is heavy. Refer to Drawing 164201300--3 in Appendix A for
weight of cabinets. If unloading instructions are not closely followed, the
cabinet may cause serious injury.
CAUTION:
Do not tilt cabinets more than 10 degrees from vertical.
1. Use a forklift or other material handling equipment to move the cabinet to the
installation area. Insert the forklift jacks between the skids on the bottom of
the unit.
2. Remove left front solid panel, and right front vented panel from UPS cabinet.
Front panel s are secured with magnetic latches and are removed by pulling
panels straight forward to disengage magnetic latches (see Figure 2---1).
3. If the leveling feet are not fully retracted, turn the leveling feet until they are
retracted.
4. Remove three bolts, (1) in Figure 2---2, securing the rear shipping bracket (3)
to the cabinet and three bolt s (2) securing the bracket to the pallet. Remove
the rear shipping bracket. If installing cabinet permanently, retain shipping
brackets and securing hardware for later use.
5. Remove three bolts, (1) in Figure 2---1, securing front shipping bracket (3) to
the pallet. Do not remove bolts (2) securing the bracket to the cabinet.
6. Remove three bolts, (4) in Figure 2---2, securing removable skid (5) and
remove skid.
NOTE: In the following step the pallet will tilt and act as a ramp once the cabinet is
rolled beyond the the center of the pallet. Make sure to restrain the cabinet
as it continues to roll down the pallet/ramp. The front shipping bracket will
act as a brake to assist restraining the cabinet.
WARNING:
Do not stand directly behind the pallet while unloading the cabinet If
unloading instructions are not closely followed, the cabinet may cause
serious injury.
7. Slowly roll the cabinet toward the rear of the pallet. O nce the pallet tilts,
continue rolling the cabinet down the pallet until the cabinet is clear of the
pallet.