Filter
Top Products
2 – QCP2330/2332
FCode
2-6 CF2351102-00 F
Q
3. Set the QCP2330/2332 HBA loop ID (see section 2.4.3).
4. Select the boot device (see section 2.4.4).
5. Build the bootable disk (see section 2.4.5).
2.4.1
Updating FCode on the QCP2330/2332 HBA
If you need to update the FCode on the QCP2330/2332 HBA, use the QLogic
qla2x00 flash utility. A QLogic Solaris SPARC driver revision 3.06 or later must be
installed before the flash utility can be run.
WARNING!!
Be very careful when changing flash contents; incorrect data may
render the QCP2330/2332 HBA unusable to the point that the
operating system may no longer function.
Perform the following steps to run the flash utility:
1. Copy the qla2x00flash file and the ifp2300.prom file to the desired directory.
2. At the command line, enter the appropriate path. Use the information obtained
with the show-devs command (see step 1 in section 2.4.4). For example:
./qla2x00flash -l /devices/pci@1f,0/pci@1/QLGC,qla@4:
devctl ifp2300.prom
2.4.2
Setting the QCP2330/2332 HBA Connection Mode
Perform the following steps to view the current QCP2330/2332 HBA connection
mode and change it if necessary:
1. To view the current connection mode, type the show-connection-mode
command:
ok show-connection-mode
The connection mode and options display. For example:
Current HBA connection mode: 1 - Point-to-point only
Possible connection mode choices:
0 - Loop Only
1 - Point-to-point only
2 - Loop preferred, otherwise point-to-point
2. If the connection mode is not correct based on the devices connected to the
QCP2330/2332 HBA, change it using the set-connection-mode command.
For example:
ok 0 set-connection-mode