4 – QSB2340/2342
FCode
CF2351102-00 F 4-3
Q
See section 6 for detailed instructions on how to install the software driver.
If you need FCode, see section 4.3 for instructions on how to install or update the
FCode on the QSB2340/2342 HBA.
4.3
FCode
This section provides instructions for installing FCode on a QSB2340/2342 HBA
installed in a Solaris SPARC system. A QSB2340/2342 HBA with FCode loaded in
its flash ROM provides boot capability to its attached devices.
The following files are included. Be sure to review the readme.txt file for both new
and changed information.
■ 2312fs.prom—FCode binary file
■ readme.txt—FCode readme file
■ qla2x00fcode—Solaris flash utility
■ readme—readme for qla2x00FCode
The procedure for installing FCode flash is summarized in the following steps and
explained in detail in the following sections.
1. Update FCode on the QSB2340/2342 HBA (see section 4.3.1).
2. Set the QSB2340/2342 HBA connection mode (see section 4.3.2).
3. Set the QSB2340/2342 HBA loop ID (see section 4.3.3).
4. Select the boot device (see section 4.3.4).
5. Build the bootable disk (see section 4.3.5).
4.3.1
Updating FCode on the QSB2340/2342 HBA
If you need to update the FCode on the QSB2340/2342 HBA, use the QLogic
qla2x00 flash utility. A QLogic Solaris SPARC driver revision 3.07 or later must be
installed before this flash utility can be run.
WARNING!!
Be very careful when changing flash contents; incorrect data may
render the QSB2340/2342 HBA unusable to the point that the
operating system may no longer function.
Perform the following steps to run the utility.
1. Copy the qla2x00fcode file and the 2312fs.prom file to the desired directory.
2. At the command line, enter the appropriate path. Use the information obtained
using the show-devs command (see section 4.3.4). For example:
qla2x00fcode -l /devices/sbus@1f,0/QLGC,qla@1,30000:
devctl 2312fs.prom