Q-Logic 2300 series Network Card User Manual


 
2 – QCP2330/2332
FCode
CF2351102-00 F 2-11
Q
10. Shut down the system. Type the following:
/sbin/init 0
11. Boot from the newly created boot disk. For example:
boot /pci@1f,0/pci@1/QLGC,qla@4/sd@82,0
NOTE: The target device ID (sd@82) is in hexadecimal. The decimal value
is used in step 3.
12. View the current dump device setting. For example:
# dumpadm
Dump content: kernel pages
Dump device: /dev/dsk/c0t0d0s1 (swap)
Savecore directory: /var/crash/saturn
Savecore enabled: yes
13. Change the dump device to the swap area of the new boot drive. For example:
# dumpadm -d /dev/dsk/c3t130d0s1
NOTE: Steps 14 and 15 set the newly created boot disk as the default boot
disk. These steps are performed at the system OBP (ok) prompt.
14. Create an alias entry for the new boot device (optional). For example:
ok nvalias fibredisk /pci@1f,0/pci@1/QLGC,qla@4/sd@82,0
15. Set default boot device to be the new boot device (optional). For example:
ok setenv boot-disk fibredisk
2.4.6
Setting and Viewing the Fibre Channel Data Rate
Use the show-data-rate command to view the current QCP2330/2332 Fibre Channel
data rate. For example:
ok show-data-rate
Current HBA data rate: One Gigabit rate
Use the set-data-rate command to change the current QCP2330/2332 Fibre
Channel data rate. For example:
ok 1 set-data-rate
Calculating NVRAM checksum, please wait...
Current HBA data rate: Two Gigabit rate