RAD Data comm RIC-155 Network Card User Manual


 
Configuring RIC-155 for Management 4-1
Chapter 4
Configuration
4.1 Configuring RIC-155 for Management
Configuration of RIC-155 is performed via menu-driven embedded software, using
a standard ASCII terminal or PC running a terminal emulation application,
connected to the rear panel CONTROL port. Alternatively, you can manage
RIC-155 over Telnet, a PC running a Web browsing application such as
ConfiguRAD or the RADview-Lite application via the MNG port.This section
describes the configuration procedures for the RIC-155 converter.
To access the Configuration menu:
From the Main menu, select Configuration.
The Configuration menu appears (see Figure 4-1).
RIC-155
Configuration
1. Quick Setup >
2. System Configuration >
3. Physical Ports Configuration >
4. Bridge Configuration >
>
Please select item <1 to 4>
ESC-prev.menu; !-main menu; &-exit
Figure 4-1. Configuration Menu
The Quick Setup menu is described in the Quick Start Guide.
Define the RIC-155 internal SNMP agent parameters in order to enable SNMP,
Telnet or Web-based management (see Figure 4-2). Also you can enter additional
information about your RIC-155, such as contact person, unit location etc.
To access the Management menu:
Follow the path: Configuration > System Configuration >Management.
The Management menu appears (see Figure 4-2).
Note