Filter
Top Products
M30850T2-EPB User’s Manual 2. Setup
REJ10J1005-0200 Rev.2.00 April 1, 2007
2.9.2 Connecting to a 100-pin 0.65mm pitch Foot Pattern (Part 1)
Figure 2.9 shows how to connect the emulation probe to a 100-pin 0.65mm pitch foot pattern on the user system with the M3T-
F160-100NRB (not included), and here following is its procedure.
For details on the M3T-F160-100NRB, refer to its user's manual.
(1) Mount the NQPACK100RB included with M3T-F160-100NRB on the user system.
(2) Attach the YQPACK100RB included with the M3T-F160-100NRB to the NQPACK100RB, and secure them with YQ-
GUIDEs.
(3) Attach the CN2 side of the M3T-F160-100NRB to the J4 side of the M30850T3-CPE.
(4) Attach the M3T-F160-100NRB to the YQPACK100RB.
*
CN2 side
(3)
(1)
100-pin 0.65mm pitch
(PRQP0100JB-A) foot pattern
No.1 pin
User system
M3T-F160-100NRB
(not included)
FLASH MCU etc
On-board evaluation
* : These four items are available in one package.
YQPACK100RB
NQPACK100RB
HQPACK100RB168
(not included)
(2)
(4)
YQ-GUIDE(x4)
These corners are not round.
M3T-FLX160-EPB
M30850T2-EPB
Figure 2.9 Connecting to a 100-pin 0.65mm pitch foot pattern (1/3)
CAUTION
Notes on Connecting the User System:
z Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator.
z The small connectors of the M3T-F160-100NRB are guaranteed for only 50 insertion/removal iterations.
z The small connectors of the M30850T2-EPB and M30800T-PTC are guaranteed for only 50 insertion/removal
iterations.
Page 31 of 98