Filter
Top Products
M34571T2-CPE User’s Manual 2. Setup
REJ10J0972-0100 Rev.1.00 February 10, 2006 Page 21 of 72
2.2 Installing the Emulator Debugger
If the OS used in your host machine is Windows XP or 2000, this installation must be executed by a user with administrator
rights. Be aware that users without administrator rights cannot complete the installation.
2.2.1 Installing the Emulator Debugger M3T-PD45M
From the CD-ROM included with your product, install the emulator debugger M3T-PD45M following the procedure described
below.
(1) Launching the installer
From Windows Explorer, etc., start the “setup.exe” program present in the \PD45M\W95E folder of the product disc.
(2) Entering the user information
In the “user information” dialog box, enter the user information (contractor, section, contact address, and host machine).
The supplied information will be turned into a format by which user registration will be provided by e-mail.
(3) Selecting components
In the “component selection” dialog box, select the components you want to install. In this dialog box you can change the
directory in which to install.
(4) Completing the installation
A dialog box will be displayed indicating that setup has been completed. It means that the installation you made is
completed.
2.2.2 Installing the USB Device Driver
Install the USB device driver following the procedure described below.
(1) Connect the host machine and the compact emulator M34571T2-CPE with the USB cable.
(2) Turn on the power to the compact emulator M34571T2-CPE.
(3) A USB device will be detected, and the wizard to install the corresponding device driver will start up.
Follow the instructions of the wizard, and a dialog box for specifying the setup information file (inf file) will appear. In
this dialog box, specify the musbdrv.inf file present in or below the directory in which you installed the M3T-PD45M
(e.g., c:\mtool\pdxx\drivers).
While you are installing, a message may be output indicating that the device driver proper musbdrv.sys cannot be found.
Because musbdrv.sys is stored in the same directory as is the musbdrv.inf file, look into the directory and specify it.