Filter
Top Products
M34571T2-CPE User’s Manual 2. Setup
REJ10J0972-0100 Rev.1.00 February 10, 2006 Page 22 of 72
2.3 Connecting the Power Supply for the Emulator
Connect the power supply for the emulator to the power connector (J1). The specification of the power supply for the emulator
is listed in Table 2.1.
Table 2.1 Specification of power supply of the emulator
Power supply voltage
DC 5.0 V±5％/2 A
Figures 2.2 and 2.3 show the specifications of the power connector (J1) and an applicable plug, respectively.
Electrode (-) Electrode (+)
φ
4.75mm
φ
1.7mm(Inside diameter)
Figure 2.2 Power connector specifications Figure 2.3 Applicable plug specifications
CAUTION
Notes on Connecting a Power Supply of the Emulator:
The power cable included in this product package is colored red (+) and black (-).
Be careful about the polarity of the power supply. Connecting to the wrong electrode could destroy internal
circuits.
Do not apply a voltage exceeding the specified voltage of the product (5.0 V ±5%), because it may cause burn
injuries and the failure of internal circuits.