Filter
Top Products
M34571T2-CPE User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0972-0100 Rev.1.00 February 10, 2006
Page 48 of 72
(2) Setting the combinatorial event condition
1. Window for setting the combinatorial event condition
2. Setting a break event
3. Timer setup area
Setting the combinatorial event condition
Select a combinatorial condition for A1, A2, and T. One o
f
the following three combinatorial conditions can be
selected..
- AND
All of the specified conditions are met.
- OR
One of the specified conditions is met.
- Sequential
The specified conditions are met sequentially in
a
specified order.
When you have finished setting the combinatorial even
t
condition, click the “Set” button.
Setting a break event
The following four break conditions can be set. You can se
t
two or more break conditions at the same time.
Break Point: The program breaks when a breakpoint is
reached.
Stack Overflow: The program breaks when the stac
k
overflow or underflows.
Trace Event: The program breaks when a trace event is met
Trace Full: The program breaks when it finished writing to
the trace memory.
Timer setup area
The following four operation modes of the timer can be
specified
.
N
otUse: The timer is not used.
TimeOut: The program loops at a constant frequency
b
reaks when a breakpoint is reached within a
specified time again. As an operating
condition, a breakpoint must be reached a
t
least once.
TimeCount: The program breaks when a specified time
has elapsed after it started running.
DelayCount: The program breaks when a specified time
has elapsed after a breakpoint is reached.
One of the following two can be specified as the coun
t
source for the timer.
TIME (10us): The passage of time if counted using the
emulator’s timer (10us fixed)
CYCLE: The passage time is counted by using MCU
cycle.