Filter
Top Products
M34571T2-CPE User’s Manual 2. Setup
REJ10J0972-0100 Rev.1.00 February 10, 2006
Page 27 of 72
Figure 2.7 Target status LEDs display when the emulator starts up normally (when user system not connected)
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system connected)
IMPORTANT
Note on the Target Status CLOCK LED:
If the LED is not turned on, check the following.
(1) After powering on the emulator (before starting up the emulator debugger):
Make sure that the oscillator circuit board is properly installed in the emulator and it is oscillating normally.
POWER
RESET
CLOCK
RUN
LED 3
LED5
LED4
LED6
: ON
: OFF
When the user system NOT connected:
The POWER LED does not light.
POWER
RESET
CLOCK
RUN
LED 3
LED 5
LED 4
LED 6
: ON
: OFF
When the user system connected:
If the POWER LED does not light,shut off
the system and check the setting of the
jumper switches and if the power is properly
supplied to the user system.