Filter
Top Products
13
B Gently insert paper face up into the bypass tray until the beeper sounds,
and then adjust the paper guides to the paper size.
If the paper size of the paper guide and the paper do not match, skewing and
misfeeds might occur.
Do not stack paper over the limit mark, otherwise a skewed image or mis-
feeds might occur.
Open out the extender to support paper sizes larger than A4 L, 8
1
/
2
×11 L.
Fan the paper to get air between the sheets to avoid a multi-sheet feed.
1. Paper Guide
2. Extender
C Set the paper size using the printer driver or the control panel.
The following procedures are not required if you select [Driver / Command]
from [Bypass Tray Setting Priority] in [System] of [Printer Features]. In that case,
set the paper size using the printer driver.
Note
❒ Paper sizes that can be loaded onto the bypass tray are 100 - 305 mm (3.9 -
12 in.) vertical, and 139.7 - 600 mm (5.5 - 23.7 in.) horizontal.
❒ If 3,000Sheet-100Sheet Staple Finisher is installed, paper of the following
dimensions can be loaded onto the bypass tray: 100 - 305 mm (3.9 - 12 in.)
vertical, and 139.7 - 458 mm (5.5 - 18.1 in.) horizontal.
❒ When loading OHP transparencies or thick paper, set paper size and paper
type.
❒ The number of sheets that can be loaded in the bypass tray depends on the
paper type.
Reference
When loading letterhead paper, pay attention to its orientation. See Gener-
al Settings Guide.
For printer driver settings, see the printer driver Help.
2
ANV012S