Filter
Top Products
Bluetooth Interface Unit Type A
33
1
D
DD
D
While holding the handle, pull
out the controller board slowly.
E
EE
E
Remove USB2.0 Interface Unit.
Note
❒ The removed screws will be
used in step
G
❒ Lift the end of USB2.0 Interface
Unit (A), and then remove it
from the controller board (B).
F
FF
F
Attach the Bluetooth Interface
Unit. Insert the end of the Blue-
tooth Interface Unit to the open-
ing (A
AA
A), and then push down
until it clicks (B
BB
B).
Confirm that the Bluetooth Inter-
face Unit is firmly connected to the
controller board.
G
GG
G
Fasten the Bluetooth Interface
Unit on the controller board using
the screws removed in step
E
EE
E
.
H
HH
H
Insert the card slowly into the
Bluetooth Interface Unit with its
side labeled "INSERT" facing up
until it stops.
ZHBP020E
ZHBPB460E
ZHBP450E
1
2
ZHBP190E
1
2
ZHBP200E
ZHBP530E
AresPGBOptionSetup-F_FM.book Page 33 Monday, July 29, 2002 1:12 PM