Filter
Top Products
Operating Instructions Administrator Reference
231
• With Windows 2000, clear the [Enable banner] check box under the [NetWare Settings] tab in the
Printer Properties dialog box.
• With Windows NT 4.0, clear the [Enable banner] check box under the [NetWare Settings] tab in the
Printer Properties dialog box.
Printing after resetting the printer
After resetting the remote printer, it will be cut off from the print server for about 30-40 seconds before
connecting again. Due to the NetWare specification, print jobs may be accepted, but they will not be
printed during this interval.
When using the printer as a remote printer, wait about 2 minutes after resetting the printer before at-
tempting to print.
Using DHCP
You can use the printer under a DHCP environment. You can also register the printer NetBIOS name
on a WINS server when it is running.
Limitation
❒ DHCP cannot be used with IEEE 1394 (IP over 1394). Set a fixed IP address with the control panel,
telnet or a Web browser.
• See the Setup Guide.
• See p.185 “TCP/IP address”.
• See p.103 “Configuring the Network Interface Board Settings”.