Filter
Top Products
Section 6: Troubleshooting
Page 6-10 GT Series Operator’s Manual
6.6 LCD WARNING MESSAGES
Error No. LCD Message Description
01
Warning: Label Near End
Cause:
Remedy:
Alarm sound:
External signal:
The label supply roll is almost running out
Be ready to replenish the label roll
One long beep
No output
02
Warning: Ribbon Near End
Cause:
Remedy:
Alarm sound:
External signal:
The amount of ribbon remaining in the printer is low
Be ready to replenish the ribbon
One long beep
Ribbon near end
03
Warning: Receive Buffer Near Full
Cause:
Remedy:
Alarm sound:
External signal:
The free space in the buffer memory is running low
Regulate the sending of data to the printer until received
data has been processed.
Three short beeps
No output
04
Warning: Command Error
Cause:
Remedy:
Alarm sound:
External signal:
A command error has been detected
Review the print data
Three short beeps
No output
05
Warning: Head Check Error
Cause:
Remedy:
Alarm sound:
External signal:
The normal head check function detected an error in the
print head, but by setting the head check function to
Barcode instead of Normal check mode, printing was
able to resume, as the error does not affect the quality of
barcodes being printing
Although the print head can still be used for now, imme-
diate attention should be given to correct the head error
or replace the print head before the situation worsens
Three short beeps
No output