Filter
Top Products
Section 3: Configuration and Operation
GT Series Operator’s Manual Page 3-19
The printer can be switched to operate in Thermal Transfer or
Direct Thermal mode with this setting.
Press the / buttons to select the TRANSFER or DIRECT
option. The default value is TRANSFER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
The printer can be switched to operate in Thermal Transfer or
Direct Thermal mode with this setting.
Press the / buttons to select the TRANSFER or DIRECT
option. The default value is TRANSFER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
This setting specifies which paper sensor is to be used: Gap
sensor (penetration sensor) and I-Mark sensor.
Press the / buttons to select between I-Mark or GAP
settings. The default value is I-MARK.
Press the ENTER button to confirm the setting and proceed to the
next screen.