Filter
Top Products
Section 2: Installation
GT Series Operator’s Manual Page 2-15
2.3 LOADING LABELS AND TAGS (CONT’D)
5. Pull out the purple label damper to release the label guide
assembly. The label guide will drop downwards.
6. Insert the paper into the label guide from a sideways
angle, so that the paper passes under the label guide and
paper sensor.
7. Adjust the label guide knob so that it lightly touches the
edge of the label. Fasten the knob tightly.
8. Now remount the print head by pushing down on the
Head lock lever. The print head should lock into place
firmly.
9. If desired, close the main cover and do a test print to
check that the label roll has been loaded properly. Be
careful not to get your fingers caught at the bottom ledge
when you are closing the main cover.
• When replacing paper, bear in mind that the print head and its surrounding
area remain hot. Keep your fingers away from these areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
Pull the
purple
label
damper.
Adjust
the label
guide
knob
Label
sensor
Print
Head
Head lock
lever