Filter
Top Products
Polling Transmission
11
1
r You can set whether a Polling
Transmission file is deleted after
transmitting in User Parameters.
To save the file to transmit repeat-
edly, set to “Standby (Save)”. See
p.159 “User Parameters” (switch
11, bit 7).
r Polling Transmission Clear Report
allows you to verify Polling Trans-
mission has taken place. See p.12
“Polling Transmission Clear Re-
port”. If E-mail TX Results is pro-
grammed in a Quick Operation
key, you can select whether a re-
port e-mail is sent after transmis-
sion. The destination of this report
can be selected from the e-mail ad-
dresses in the destination list.
r You can program one of the Quick
Operation keys with operations for
this function. Using the key allows
you to omit steps B and C.
r The communication fee is charged
to the receiver.
r This function is not available with
Internet Fax transmission.
A Place the original, and then select
the scan settings you require.
Reference
p.15 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.33 “Scan Settings”, Facsimile
Reference <Basic Features>
B Press [Transmission Mode].
C Press [Polling TX].
D Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:
Free Polling Transmission
A Check that [Free Polling TX] is se-
lected.
Default ID Transmission
A Select [Default ID TX].
ID Override Transmission
A Select [ID Override Transmission].
B Specify a 4-digit ID using the
number keys and [A], [B], [C],
[D], [E], and [F].
Note
r A Polling ID may be any four
numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.
r If you make a mistake, press
[Clear] or the {Clear/Stop} key,
and then try again.