Filter
Top Products
Transmission Mode
12
1
E Press [Only Once] or [Save] to delete
or save the file after transmission.
Note
r To delete the original immedi-
ately after transmission, select
[Only Once].
r To repeatedly send the original,
select [Save].
r To cancel Polling Transmission,
press [Cancel]. The display re-
turns to that of step
C
.
F Press [OK].
“p ppppppppp” ap-
pears.
The type of Polling Transmission is
shown above the highlighted [Poll-
ing TX].
G Press [OK].
Note
r To check the settings, press
[Transmission Mode].
H Press the {Start} key.
Note
r You can cancel the transmission
setup for Polling Transmission.
See p.19 “Canceling a Transmis-
sion”.
Polling Transmission Clear
Report
This report allows you to verify Poll-
ing Transmission has taken place.
If E-mail TX Results is programmed
in a Quick Operation key, you can
have the report e-mail sent after
transmission.
Limitation
r This report is not printed if the
User Parameters are set to allow
the stored originals to be repeated-
ly sent (Save). See p.159 “User Pa-
rameters” (switch 11, bit 7).
Note
r You can turn this function on or off
with the User Parameters. See
p.159 “User Parameters” (switch
03, bit 6).
r You can have a portion of the sent
image printed on the report with
the User Parameters. See p.159
“User Parameters” (switch 04, bit
7).
r You can check the result of Polling
Transmission with the Journal. See
p.27 “Printing the Journal”
r To view the report without text
disruption, select a font of even
character width in your e-mail ap-
plication's settings.