Filter
Top Products
Troubleshooting and routine maintenance
C - 33
C
OPC belt cartridge
Replace OPC belt cartridge message
When the OPC belt cartridge runs out, the
following message appears on the LCD.
When you see this message, you must
replace the OPC belt cartridge:
Replacing the OPC belt cartridge
(Photo Conductor Unit Type 140)
1
Turn off the machine’s power switch.
2
Open the scanner unit.
3
Open the inside cover so that it latches
under the scanner unit.
4
To release the lock, push the green belt
cartridge lock levers on both sides
inwards.
5
Remove the OPC belt cartridge from the
machine.
6
Remove the tension release pins from
both sides of the new OPC belt
cartridge.
IMPORTANT
■ Do not touch the green film of the OPC
belt cartridge. If you touch it, it could
degrade print quality.
■ Do not expose the OPC belt cartridge
to bright room light or sunlight (a light
source of 74.3 footcandles or 800 lux)
for more than two minutes to avoid
damaging the belt.
■ Damage caused by improper handling
of the OPC belt cartridge may void your
warranty.
Replace OPC Belt