Filter
Top Products
Optional accessories
D - 4
D
3
Unscrew the screw holding the side
cover, and then slide the side cover to
remove it.
4
Unscrew the screw holding the metal
shield plate, and then remove the metal
shield plate.
5
Unpack the SO-DIMM and hold it by the
edges.
6
Hold the SO-DIMM with your fingers on
the side edges and your thumb on the
back edge. Align the notch on the
SO-DIMM with the protrusions with the
SO-DIMM slot. (Check that the locks on
each side of the DIMM slot are open or
facing outwards.)
7
Press the SO-DIMM straight into the slot
(press firmly). Make sure the locks on
each side of the SO-DIMM click into
place.
Note
To remove the SO-DIMM, open the retaining
clips on both sides of the SO-DIMM by
pushing them outward, grasp both edges of
the SO-DIMM and pull it out straight.
8
Secure the metal plate with the screw.
IMPORTANT
SO-DIMM boards can be damaged by
even a small amount of static electricity.
Do not touch the memory chips or the
board surface. Wear an antistatic wrist
strap when you install or remove the
board. If you do not have an antistatic wrist
strap, keep touching the bare metal on the
machine.