Filter
Top Products
A-10 Scorpion 240 Autoloader Installation Manual
Installing the internal autoloader
This chapter describes how to configure, mount, and attach
cables to the
internal
Scorpion 240 autoloader.
Configuring the internal autoloader
Before you install the internal version of the Scorpion 240 in
your computer, you may need to configure the drive to work
with your system.
Default settings
The default settings for the internal drive are listed below:
•
The drive is set for SCSI ID 6.
•
Parity checking is enabled.
•
SCSI terminator power is disabled.
•
Data compression is enabled.
•
Power-on self-test diagnostics are enabled.
•
MRS checking is enabled
(the drive will not write to non-MRS tapes).
If these default settings are appropriate for your computer
system, then continue to “Mounting the internal autoloader” on
page A-15.
Changing jumper settings
To change the SCSI ID, parity checking, or termination power,
use the jumpers on the back of the drive, as shown in Figure
1 on the following page.
Note.
Power down the drive before changing jumpers or dip
switches. Changes take effect when the drive restarts.