Filter
Top Products
Scorpion 240 Autoloader Installation Manual A-19
Figure 6. Rear panel of external Scorpion 240
+
–
68-pin wide SCSI
connectors
SCSI ID selector
On/Off switch
AC Power connector
Connecting the SCSI interface cable
The Scorpion 240 provides two 68-pin, shielded connectors
on the rear panel of the enclosure. Either connector can be
used as a SCSI IN or SCSI OUT connection (you can use
either connector to attach the drive to the host computer or to
another SCSI device).
Turn off your computer and all SCSI devices. Then attach a
SCSI cable from the host adapter or from another
(unterminated) SCSI device to the Scorpion 240
Note:
The Scorpion 240 will not work in a SCSI-1
environment.
SCSI termination
If the Scorpion 240 is the last device or the only device in a
SCSI chain, you must install a terminating plug on the unused
SCSI connector. See Figure 7 on the following page for two
SCSI termination examples. You can purchase a terminator
for the Scorpion 240 (part number 10006525-001) on the web
at http://buytape.seagate.com.