Filter
Top Products
11
6 O O-C
1
0
2
3
4
5
6
7
8
9
10
(Reset Up)
Reset Power After
Emergency Stop
0
20
40
60
80
100
120
140
160
FRONT CONTROL PANEL
1. Air Regulator Knob: Adjusts the downward
pressure of the top roller. Turn clockwise to
increase the pressure.
2. Air Pressure Gauge: Indicates the PSI reading for
the downward pressure of the top main roller. The
standard setting for the normal operation is 35-55
PSI.
3. Roller Up/Down Switch (Front, Top): Press UP to
raise the roller. Press DOWN to lower the roller.
Reset this switch (press UP, then DOWN) after
pressing an Emergency Stop.
4. Speed Adjustment Knob: Use this knob to adjust
the speed of the roller rotation. Turn the knob
clockwise to increase the speed, and counter-
clockwise to decrease the speed.
5. Motor ON/OFF Switch: Press UP to start the
roller rotation, the switch will be illuminated. Press
the switch DOWN to stop the roller rotation. In the
OFF position, the footswitch can be used for roller
rotation.
6. Power Indicator Light: This light is illuminated
when the power is turned ON and all functions are
then operable.
7. Stand-by On/Off Switch: Press the switch UP to
turn on the laminator. Press this switch DOWN to
put it on Standby. In Standby, the laminator power
is still on, but all functions are disabled.
Figure 4. Front Control Panel
2
1
3
5
7
4
6