Filter
Top Products
31
LIMITED WARRANTY
SEAL
®
Graphics warrants to the original consumer
purchaser that each new SEAL
®
Image
®
Laminator,
which proves defective in materials or workmanship
within the applicable warranty period, will be repaired or,
at our option, replaced without charge.
Effective November 1st, 2002 the applicable warranty
period for New Equipment shall be one year (parts), six
months (labor and rollers) from date of purchase.
This warranty extends to and is enforceable by only the
original consumer purchaser, and only for the period
(during the applicable term), which the product remains
in the possession of the original consumer purchaser.
"Original consumer purchaser" means the person who
first purchased the product covered by this warranty
other than for purpose of resale. This warranty does not
apply if it is found that at any time the equipment has not
been used for its intended purpose.
Effective November 1st, 2002 the applicable warranty
period for Refurbished Equipment shall be ninety days
(parts and labor, excluding rollers). Rollers are not
covered under warranty. The applicable warranty period
for Demo Equipment shall vary, not exceeding the
maximum warranty period stated herein. All Demo
Equipment comes with a specific warranty, which will be
stated at the time of purchase. If warranty period is not
detailed in writing, there is no remaining warranty.
Please ask your dealer, distributor, or sales representative
for details.
NOTE: Used and Not Refurbished Equipment is sold
on an “AS IS” basis with No Warranty.
For more information regarding this warranty, please
contact your distributor.
WARNING! Any unauthorized changes or
modifications to this unit without our prior written
approval will void the user’s warranty and will
transfer health and safety obligations to the user.
WARNING! Changes or modifications to this unit
not expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment
NOTE: This equipment has been tested and found
to comply with the limits for a class A digital device,
pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with Owner’s Manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case
the user will be required to correct the interference
at their own expense.
©Copyright SEAL
®
Graphics 2002
All rights are reserved. No part of the document may be
photocopied, reproduced, or translated to another
language without the prior written consent of SEAL
Graphics.
The information contained in this document is subject to
change without notice and should not be construed as a
commitment by SEAL Graphics.
SEAL Graphics assumes no responsibility for any errors
that may appear in this document. Nor does it make
expressed or implied warranty of any kind with regard to
this material, including, but not limited to, the implied
warranties of merchantability and fitness for a particular
purpose.
SEAL Graphics shall not be liable for incidental or
consequential damages in connection with, or arising out
of the furnishing, performance, or use of this document
and the program material, which it describes.
Trademarks Credits
SEAL
®
is a registered trademark of SEAL Graphics.
Image
®
is a registered trademark of SEAL Graphics.
AquaSEAL
®
is a registered trademark of SEAL Graphics.
ProSEAL
®
is a registered trademark of SEAL Graphics.