Filter
Top Products
28
TROUBLESHOOTING GUIDE
Problem Solution
The laminator will not turn on.
• Check if the power cable is plugged into the mains wall outlet.
• Check that the Main Power Stand-by switch is ON.
• Unplug the laminator and check the circuit breakers and fuses inside the
left cabinet. Only authorized safety or maintenance personnel should do
this.
• Make sure the left side cabinet door is closed and the Door interlock is
in the ON position. Turning the door interlock to the OFF position
automatically shuts the laminator power off.
The motor will not run.
• Make sure that the photo-eyes are not blocked.
• Make sure that the Emergency Stop buttons were not activated. Rotate
to reset.
• Check that the Motor switch is pressed ON (switch will be illuminated).
• Turn the motor speed up.
• Unplug the laminator and check the fuses. Only authorized safety or
maintenance personnel should do this.
Images or Prints are rippling or
jumping as they are fed into the nip.
• Apply tension to Images or Prints as they are fed into the nip. Hold cut
sheets back by hand.
The film output is rippled or wavy
(boat-waking)
• Check that you have webbed the laminator correctly.
• Improper film tension – most encapsulating films need a minimal
amount of brake tension.
The film is cloudy or mottled.
• Thicker films may require increased roller pressure due to the thicker
film layer.
TECHNICAL SERVICE
For technical assistance, please contact your Technical Service representative (see rear cover).
When calling for Technical Service please have the Laminator Serial Number (listed on the Identification Plate)
available. The Identification plate is located on the rear side of the laminator.