Filter
Top Products
12
CHECKING OPERATION
After you are familiar with the control panel and its
functions, check all operations.
CHECK THE MAIN POWER
• Press the main power stand-by switch UP and the
Power Indicator Light on the control panel should
be lit.
• If there is no power, refer to the Troubleshooting
Page.
CHECK THE EMERGENCY STOP BUTTONS
• Press one of the Emergency Stop Buttons and the
laminator will shut down.
• Rotate the Emergency Stop Button clockwise to
reset.
• Reset the main power switch (press UP, then
DOWN).
• Repeat this procedure with both Emergency Stop
Buttons.
CHECK THE MOTOR AND FOOTSWITCH
• Push the green Motor Switch UP, the switch will be
illuminated and the rollers should rotate in the
forward direction.
• As you turn the speed control knob clockwise the
speed of the roller rotation should increase.
• Turning the speed control knob counter-clockwise
should decrease the speed of the roller rotation.
• Press the green Motor Switch DOWN and the
rollers should stop rotating.
• Press the footswitch and the rollers should rotate.
• Turn the speed control knob while using the
footswitch to verify the speed increases and
decreases.
CHECKING THE ROLLERS
Your laminator has pneumatic pressure adjustment with
fine-tune control for a smooth, flat finish. Correct
adjustment of the pressure rollers’ height is essential for
safe and proper operation. Check this prior to every use.
Check the vertical movement of the top rollers
as follows:
• Press the Roller switch UP. The top roller should
rise smoothly and evenly on both ends.
• Press the Roller switch DOWN. The top roller
should lower smoothly and evenly on both ends.
IMPORTANT: The silicone covering of the
rollers is soft. Do not scratch the surface with a
sharp object or fingernail.
WARNING! If your laminator does not operate
correctly, contact Technical Service
immediately.