Filter
Top Products
3-23
Section 3 Operation Panel Menu Operations
(12) Wind value setting for FAN (VACUUM)
Sets wind value for FAN.
<Parameter (Enter a choice)>
- NORMAL: Absorbs the paper at the normal wind value.
- LOW: Absorbs the paper at the low wind value.
(13) Wait of heating setting (WAIT HEATER)
Sets whether print should wait for time that the heater temperature
reaches the preset temperature.
<Parameter (Enter a choice)>
-WAIT:Waits the time until the heater temperature reaches
the preset temperature.
- SKIP: Starts printing even if the heater temperature does
not reach the preset temperature.
(14) Initial temperature setting for the front heater (FRONT HEATER)
Sets the front heater temperature.
(Celsius) (Fahrenheiht)
<Parameter (Enter a value)>
- Range: 15 °C to 55 °C
(The heater will be OFF when "**" is set.)
#VACUUM
>01 : NORMAL
#WAIT HEATER
>01 : WAIT
#FRONT HEATER
>01 : 086F
#FRONT HEATER
>01 : 30C
Menu Operations