Filter
Top Products
2-51
Section 2 Basic Operations
NOTE
<Test Print>
Enter to the “ADJUST” menu and select “TEST PRINT” on the
operation panel. (See page 3-19.)
Check no print dot-off and missing.
Perform the test print as the 1st time print on every day and especially
after cap cleaning for head cleaning.
When the print dot-off occurs at test print, enter to the “CLEANING”
menu and select “NORMAL.” (See page 3-25.)
- Do not leave the head carriage at the position other than
on the capping unit for a long time (more than 5 minutes).
- Perform the normal head cleaning after completion of the
test print.
Check no dregs of the dried ink and no damage on the blades.
Clean the front and back of the blades with the swab infiltrated into
the wiper cleaning liquid.
After completion of the cleaning, close the wipe cover and the rear
cover to return the wiper to the position as it was.
Wiper blades
Inspection & Maintenance
Note: Do not use the same swab for each wiper