Filter
Top Products
Answering machine connection
92
Reception and copying problems
The power is on, but no
transmission takes place.
• Make sure that the receiving machine has fax paper.
• Make sure that the telephone line cord is plugged into
the TEL. LINE socket, and not the TEL. SET socket.
• If the receiving machine is in manual mode with no
attendant, reception will not be possible.
• If the receiving machine is not a Sharp model, make
sure it is G3 compatible.
• Check the display for error messages.
• Pick up the handset and check for a dial tone. Call the
receiving machine by normal (manual) dialling, and
confirm its response.
Nothing is printed at the
receiving end.
• Make sure that the document for transmission is
placed face down in the feeder.
A distorted image is
received at the other end.
• Noise on the telephone line may cause distortion. Try
sending the document again.
• Make a copy of the document on your fax. If the copy
is also distorted, your fax may have a problem. If the
problem persists, call for service.
Problem Check and remedy
The power is on, but no
reception takes place.
• Make sure the wall socket is connected to the TEL.
LINE socket, and not the TEL. SET socket.
The printing paper comes
out blank when you try to
receive a document.
• Make sure that the document is loaded properly in the
feeder of the transmitting machine. Make a copy to
confirm the printing ability of your machine.
all_fo781a.book Page 92 Thursday, January 11, 2001 12:06 PM