Filter
Top Products
Sending an Image Using a Rapid Key or Speed Dial Number
92
Sending an image using a Speed Dial number
Use this procedure to scan a document and send the image to an E-mail, FTP,
or Desktop destination that has been stored in a Speed Dial number.
Important: To use this procedure, the setup procedures outlined on page 74
must be completed. In the case of Scan to E-mail, this includes setting a
default sender as explained in the procedure beginning on page 85 of this
manual.
♦ If you are sending the image to an e-mail destination and need to change
the subject, use the procedure on page 85.
1
Load the document(s).
• SEND READY will appear in the
display.
• Press and/or to set
the resolution and contrast if needed.
The default resolution is FINE. Note
that STANDARD and SUPER FINE are
primarily for faxing and are not
recommended for scanning.
2
Press and then enter the Speed Dial number by pressing the
numeric keys.
• If you enter less than 3 digits for the Speed Dial number, press to
complete the entry.
• Check the display to make sure the destination shown is correct (if not,
press and repeat Step 2).
RESOLUTION
CONTRAST
SPEED DIAL
START/
ENTER
STOP
all.book Page 92 Thursday, May 13, 2004 8:51 AM