Filter
Top Products
Connecting the Power Cord
9
1. Installation
Plug the power cord into a 120 V, 60 Hz,
grounded AC (3-prong) outlet.
Caution! Do not plug the power cord
into any other kind of outlet. This will
damage the machine and is not
covered under the warranty.
Caution! Remove all packing tape
before plugging in the power cord
(see page 7), or damage to the
machine may result.
The display will show [CHECK
CARTRIDGE] until you install the print
cartridge.
Connecting the Power Cord
♦
It is recommended that you install
surge protectors for the power and
telephone lines. Surge protectors can
be purchased at most telephone
specialty stores.
Print cartridge yield
SHARP UX-C80B replacement
cartridge
Ink Save mode OFF:
Approx. 480 letter pages
Ink Save mode ON:
Approx. 800 letter pages
(The initial cartridge has the same
yield as the replacement cartridge.)
♦ Ink Save mode is initially turned off.
To turn on Ink Save mode, see
pages 45 and 49.
Installing the Print Cartridge
Caution! Do not open the cover while
the machine is printing.
Note: Keep print cartridges sealed in
their packages until you are ready to
install them. It is recommended that you
do not use a cartridge that has been left
unused for a long time after opening, as
the print quality may be considerably
degraded.
♦ Make sure the machine’s power cord
is plugged in and paper is loaded in
the paper tray.
1 Open the cover (grasp the finger
grip).
If at any time the display shows [ADD
PAPER &] / [PRESS START KEY
],
check the paper tray. If the tray is
empty, add paper. If there is paper in
the tray, take it out and then reinsert it.
When finished, press .