Support User Manuals

Sierra Raven EDGE Network Card User Manual

Open as PDF

of 141

Configuring your Raven

Rev 3.0B Feb.08 42

b. TypeATandpressEnter.Youshouldgetareplyof

“OK”or“0”.

c. Toseewhatyouaretypingasyoutypeit,youwill

needtoturnontheechoand verbosemode.Type

ATE1V1andpressEnter.

d. Ifyougetareplyof“OK”,thenyouenteredthe

commandsuccessfully.Ifyougetareplyof“0”or

“ERROR”,tryenteringthecommandagain.

AT Commands

Whenusingaterminalapplication,youwillneedtomanually

typeineachcommand.

• Formostcommands,whenyouareenteringthemusinga

terminalconnection,youwillneedtoprefacethe

commandwithAT(exceptionsarenoted),i.e.AT Awhich

islistedasA.

• Somecommandshavespecificparameterswhileother

commandswilltakewhateveryoutype.

• Requiredvariableparametersaredenotedwithitalicized

text,example,Dn.Thenisvariable.

• Acceptableparametersand/orspecificformatsarelisted

witheachcommand.

• Mostcommandswithparameterscanbeenteredwith?to

readthecurrentvalue(forexample,AT&D?willrespond

with“2”ifthedefaulthasnotbeenchanged).

• Optionalparametersaredenotedwithsquarebrackets[].

• ATCommandsarenotcasesensitive.Acapital“E”isthe

sameasalower‐case“e”.

• Whenyouareusingaterminalconnection,ifyouentera

commandwhichisrecognizedbytheRaven,itwill

respondwith“OK”.Ifthecommandisnotrecognized,the

responsewillbe“ERROR”.

• Thosecommandsapplicableonlytocertainmodel

numbersoftheRavenwillbenoted.

Caution: Symbols listed with commands, such as *, /, &, or ?, are

part of the command and must be included. Commands with symbols

other than * may require PassThru mode.

previous next