Support User Manuals

Sierra Raven EDGE Network Card User Manual

Open as PDF

of 141

Raven EDGE

93 20070914

PassThru

PassThruModeisusedtocommunicatedirectlytotheRaven

internalhardware.

Caution: While the modem is in PassThru mode, ALEOS is disabled.

If you need to connect to the Raven while it is in PassThru mode, you

will need to do so with a terminal application. Not all commands are

available while the modem is in PassThru mode.

Figure 1-7: AceManager : PassThru

\APASSTHRU

Note: This mode is not available

through the remote AT telnet

server. You will need to connect

to the Raven with it connected

directly to your computer.

Setsthemodemoperationtopassthroughmode.Thismode

willpassanycharactersreceivedontheportEthernetdirectly

totheinternalhardwaremoduleandoutputanycharacters

fromtheinternalhardwaremoduleouttheportEthernet.This

allowsdirectaccess/configurationofthehardwaremodule.

Oncethismodeisentered,

theunitmustbephysicallyresetto

returntonormaloperation.Thiscommandisnotavailablein

AceManager.

Note: It may take up to 30 seconds for the hardware module to

respond after CONNECT is output.

*CSX1=n

PassThruEcho:Echodatatothe host.

• n=0:Datawillbepassedtothehost.

• n=1:PASSTHRUmodewillechoallhostreceiveddata

andwillnotpassthedatatothemodemwhilethemodem

isnotassertingDCD.

Note: If the modem is asserting DCD, data will be passed from the

host to the modem as it normally is when *CSX1=0.

previous next