Filter
Top Products
Submenu setting Description
IP Address Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Gateway Displays or allows you to set the projector’s default network gateway
in values between 0.0.0.0 and 255.255.255.255.
DNS Displays or allows you to set the projector’s IP address for your
network’s primary domain name server in values between 0.0.0.0 and
255.255.255.255.
Group Name Displays or allows you to set the projector’s workgroup name
(maximum 12 characters).
Projector Name Displays or allows you to set the projector’s name (maximum 12
characters).
Location Displays or allows you to set the projector’s location (maximum 16
characters).
Contact Displays or allows you to set the contact name or number for projector
support (maximum 16 characters).
SNMP Turns the Simple Network Management Protocol (SNMP) agent on or
off.
Read-Only Community Sets a password that is required for each SNMP get request to
thedevice.
N OTE
The default password for Read-Only Community is public.
Read/Write Community Sets a password that is required for each SNMP set request to the
device.
N OTE
The default password for Read/Write Community is private.
Trap Destination Address Displays or allows you to set the IP address of your network’s SNMP
TRAP manager in values between 0.0.0.0 and 255.255.255.255. The
trap destination address is the IP address of the computer assigned to
handle unsolicited data generated by SNMP TRAP events generated
by the projector, such as power state changes, projector failure
modes, a lamp needing to be replaced or other issues.
C H AP T ER 7
Remotelymanaging your interactive projector
58