Filter
Top Products
C
ONFIGURING
THE
S
WITCH
3-80
CLI – Specify all the required parameters to enable logon authentication.
Configuring HTTPS
You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch’s web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on
the switch. However, you cannot configure both services to use the same
UDP port.
Console(config)#authentication login radius 4-92
Console(config)#radius-server port 181 4-96
Console(config)#radius-server key green 4-96
Console(config)#radius-server retransmit 5 4-97
Console(config)#radius-server timeout 10 4-97
Console(config)#radius-server 1 host 192.168.1.25 4-95
Console(config)#exit
Console#show radius-server 4-98
Remote RADIUS server configuration:
Global settings:
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Server 1:
Server IP address: 192.168.1.25
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Console#config
Console(config)#authentication login tacacs 4-92
Console(config)#tacacs-server host 10.20.30.40 4-99
Console(config)#tacacs-server port 200 4-100
Console(config)#tacacs-server key green 4-100
Console(config)#exit
Console#show tacacs-server 4-101
Server IP address: 10.20.30.40
Communication key with tacacs server: *****
Server port number: 200
Console(config)#