SMC Networks SMC8724ML3 Switch User Manual


 
SNMP C
OMMANDS
4-139
SNMP Commands
Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
SNMP Version 3 also provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific
areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or
accept the default), specify read and write access views for the MIB tree,
configure SNMP user groups with the required security model (i.e., SNMP
v1, v2c or v3) and security level (i.e., authentication and privacy), and then
assign SNMP users to these groups, along with their specific authentication
and privacy passwords.
Table 4-37 SNMP Commands
Command Function Mode Page
snmp-server Enables the SNMP agent GC 4-140
show snmp Displays the status of SNMP communications NE,
PE
4-140
snmp-server
community
Sets up the community access string to permit
access to SNMP commands
GC 4-141
snmp-server contact Sets the system contact string GC 4-142
snmp-server location Sets the system location string GC 4-143
snmp-server host Specifies the recipient of an SNMP
notification operation
GC 4-143
snmp-server enable
traps
Enables the device to send SNMP traps (i.e.,
SNMP notifications)
GC 4-146
snmp-server
engine-id
Sets the SNMP engine ID GC 4-147
show snmp engine-id Shows the SNMP engine ID PE 4-149
snmp-server view Adds an SNMP view GC 4-150
show snmp view Shows the SNMP views PE 4-151
snmp-server group Adds an SNMP group, mapping users to
views
GC 4-152