Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-14
DC (DHCP Server Configuration)
RC (Router Configuration)
CM (Class Map Configuration)
PM (Policy Map Configuration)
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
Table 4-5 Line Commands
Command Function Mode Page
line Identifies a specific line for configuration and
starts the line configuration mode
GC 4-15
login Enables password checking at login LC 4-16
password Specifies a password on a line LC 4-17
timeout login
response
Sets the interval that the system waits for a login
attempt
LC 4-18
exec-timeout Sets the interval that the command interpreter
waits until user input is detected
LC 4-19
password-thresh Sets the password intrusion threshold, which limits
the number of failed logon attempts
LC 4-20
silent-time
*
Sets the amount of time the management console
is inaccessible after the number of unsuccessful
logon attempts exceeds the threshold set by the
password-thresh command
LC 4-21
databits
*
Sets the number of data bits per character that are
interpreted and generated by hardware
LC 4-21
parity
*
Defines the generation of a parity bit LC 4-22
speed
*
Sets the terminal baud rate LC 4-23
stopbits
*
Sets the number of the stop bits transmitted per
byte
LC 4-24