SMC Networks SMC8724ML3 Switch User Manual


 
S
PANNING
T
REE
A
LGORITHM
C
ONFIGURATION
3-173
re-check the appropriate BPDU format (RSTP or STP-compatible) to
send on the selected interfaces. (Default: Disabled)
Web – Click Spanning Tree, STA, Port Configuration or Trunk
Configuration. Modify the required attributes, then click Apply.
Figure 3-71 STA Port Configuration
CLI – This example sets STA attributes for port 7.
Configuring Multiple Spanning Trees
MSTP generates a unique spanning tree for each instance. This provides
multiple pathways across the network, thereby balancing the traffic load,
preventing wide-scale disruption when a bridge node in a single instance
fails, and allowing for faster convergence of a new topology for the failed
instance.
By default all VLANs are assigned to the Internal Spanning Tree (MST
Instance 0) that connects all bridges and LANs within the MST region.
This switch supports up to 65 instances. You should try to group VLANs
which cover the same general area of your network. However, remember
that you must configure all bridges within the same MSTI Region
Console(config)#interface ethernet 1/7 4-187
Console(config-if)#no spanning-tree spanning-disabled 4-234
Console(config-if)#spanning-tree port-priority 0 4-236
Console(config-if)#spanning-tree cost 50 4-235
Console(config-if)#spanning-tree link-type auto 4-239
Console(config-if)#no spanning-tree edge-port 4-237
Console(config-if)#spanning-tree protocol-migration 4-242