SMC Networks SMC8724ML3 Switch User Manual


 
IP R
OUTING
C
OMMANDS
4-317
Command Mode
Interface Configuration (VLAN)
Command Usage
Proxy ARP allows a non-routing device to determine the MAC address of
a host on another subnet or network.
Example
IP Routing Commands
After you configure network interfaces for this router, you must set the paths
used to send traffic between different interfaces. If you enable routing on this
device, traffic will automatically be forwarded between all of the local
subnetworks. However, to forward traffic to devices on other subnetworks,
you can either configure fixed paths with static routing commands, or enable
a dynamic routing protocol that exchanges information with other routers on
the network to automatically determine the best path to any subnetwork.
This section includes commands for both static and dynamic routing. These
commands are used to connect between different local subnetworks or to
connect the router to the enterprise network.
Console(config)#interface vlan 3
Console(config-if)#ip proxy-arp
Console(config-if)#
Table 4-80 IP Routing Commands
Command Group Function Page
Global Routing
Configuration
Configures global parameters for static and dynamic
routing, displays the routing table, and statistics for
protocols used to exchange routing information
4-318
Routing
Information
Protocol (RIP)
Configures global and interface specific parameters for
RIP
4-324
Open Shortest Path
First (OSPF)
Configures global and interface specific parameters for
OSPF
4-338