Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-144
• inform - Notifications are sent as inform messages. Note that this
option is only available for version 2c and 3 hosts. (Default: traps are
used)
- retries - The maximum number of times to resend an inform message
if the recipient does not acknowledge receipt. (Range: 0-255;
Default: 3)
- seconds - The number of seconds to wait for an acknowledgment
before resending an inform message. (Range: 0-2147483647
centiseconds; Default: 1500 centiseconds)
• community-string - Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you can
set this string using the snmp-server host command by itself, we
recommend that you define this string using the snmp-server
community command prior to using the snmp-server host
command. (Maximum length: 32 characters)
• version - Specifies whether to send notifications as SNMP Version 1,
2c or 3 traps. (Range: 1, 2c, 3; Default: 1)
- auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy. See “Simple Network Management Protocol” on page 3-50
for further information about these authentication and encryption
options.
• port - Host UDP port to use. (Range: 1-65535; Default: 162)
Default Setting
• Host Address: None
• Notification Type: Traps
• SNMP Version: 1
• UDP Port: 162
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server host command, no notifications are
sent. In order to configure the switch to send SNMP notifications, you
must enter at least one snmp-server host command. In order to enable