Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-146
7. Then configure a remote user (page 4-154).
• The switch can send SNMP Version 1, 2c or 3 notifications to a host IP
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the
SNMP version, the default is to send SNMP version 1 notifications.
• If you specify an SNMP Version 3 host, then the community string is
interpreted as an SNMP user name. If you use the V3 “auth” or “priv”
options, the user name must first be defined with the snmp-server user
command. Otherwise, the authentication password and/or privacy
password will not exist, and the switch will not authorize SNMP access
for the host. However, if you specify a V3 host with the “noauth” option,
an SNMP user account will be generated, and the switch will authorize
SNMP access for the host.
Example
Related Commands
snmp-server enable traps (4-146)
snmp-server enable traps
This command enables this device to send Simple Network Management
Protocol traps or informs (i.e., SNMP notifications). Use the no form to
disable SNMP notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure
notifications.
• link-up-down - Keyword to issue link-up or link-down notifications.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#