SMC Networks SMC8724ML3 Switch User Manual


 
U
SER
A
UTHENTICATION
3-101
Filtering IP Addresses for Management Access
You can create a list of up to 16 IP addresses or IP address groups that are
allowed management access to the switch through the web interface,
SNMP, or Telnet.
Command Usage
The management interfaces are open to all IP addresses by default. Once
you add an entry to a filter list, access to that interface is restricted to the
specified addresses.
If anyone tries to access a management interface on the switch from an
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap manager.
IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets of
addresses, either individual addresses or address ranges.
When entering addresses for the same group (i.e., SNMP, web or Telnet),
the switch will not accept overlapping address ranges. When entering
addresses for different groups, the switch will accept overlapping address
ranges.
You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
You can delete an address range just by specifying the start address, or
by specifying both the start address and end address.
Command Attributes
Web IP Filter – Configures IP address(es) for the web group.
SNMP IP Filter – Configures IP address(es) for the SNMP group.
Telnet IP Filter – Configures IP address(es) for the Telnet group.
IP Filter List – IP address which are allowed management access to this
interface.
Start IP Address – A single IP address, or the starting address of a
range.
End IP Address – The end address of a range.