Filter
Top Products
1-57
BEFORE USING THE MACHINE
5
Shake the new developer cartridge 5 or 6
times as shown.
Hold the developer cartridge firmly as shown below and shake
forward and back, left and right.
Remove the protective material after shaking the developer
cartridge.
• The part of the developer cartridge shown in the next illustration is easily
deformed or damaged. Do not touch this part when handling the cartridge.
• Do not touch the roller in the developer cartridge. If the roller is accidentally
touched, image problems may result. In that case, replace the developer cartridge
with a new cartridge.
• The seal must not be removed when shaking the new developer cartridge.
• Take care not to damage the developer cartridge when shaking it. If damaged, the
developer in the cartridge may leak out.
6
Insert the new developer cartridge
horizontally.
Insert the new developer cartridge in the same location as the
cartridge that was removed.
• Do not tilt the developer cartridge or insert it in the wrong direction or orientation. This may damage the developer
cartridge or drum cartridge and cause failure.
• When inserting the developer cartridge, grasp it with both hands at the middle.
• Do not remove the seal from the developer cartridge until the cartridge is installed in the machine. If the seal is
removed when the cartridge is not locked, the cartridge may fall out of the machine.
Insert with the arrow on the cartridge aligned with the arrow on the machine.
7
Detach the end of the seal from the
developer cartridge.
Align the notch in the seal with the tab on the attachment part
and pull up. Be careful not to completely remove the seal by
pulling too hard.
Protective material